Zoom 9000 Spécifications télécharger pdf (Page 17)

Storing the Desired Patch in a Different Bank

The desired Bank number must be specified when selecting the desired Patch on the

9000. Setting the required Patches, which are to be used in a piece of music, in the same

Bank makes the operation easy. The section explains how to move a Patch from one

Bank to another, and how to store the Patch with a different Patch number.

· In the Play mode, select the desired Patch to be stored in the different

Bank.

· Press the STORE key.

This operation puts the 9000 in a Standby status for the store operation, and both the

Bank number and Patch number start flashing.

STORE

VOL 100 31 STORE 31

CANCEL

· Using the BANK DOWN/UP key and the PATCH 1 to 4 key(s), specify the

Bank number and then the Patch number with which the Patch is to be

stored.

Note:

When store operation of new data is carried out, the data currently being stored in the

Bank will be deleted first. Be sure that the Patch currently being stored is not necessary.

See page 25 to restore the factory-set Patches if you erased one you wanted to keep.

· Press the STORE key again, This operation stores the Patch in the

Bank.

Helpful hint:

Pressing the EDIT/CANCEL key instead of pressing the STORE key for the second time

stops the store operation, and the 9000 goes back into the Play mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 44 45

Pas de commentaire

Zoom 9000 Spécifications Page 17