Zoom G2 Spécifications télécharger pdf (Page 6)

ZOOM G2

Using the Tuner

B P

Switch to bypass or mute

Setting the G2 to the bypass state

In play mode, press both [W]/[Q] foot

switches together briefly and release.

Setting the G2 to the mute state

In play mode, press both [W]/[Q] foot

switches together and hold for at least 1

second.

When you press both [W]/[Q] foot switches together while

playing your instrument, the bypass/mute condition is

activated. However, the sound may change momentarily

just before the condition is activated. This is because the

G2 switches to the next higher or lower patch when one of

the foot switches is pressed slightly earlier. (When you

cancel the bypass/mute condition, the original patch

number will be active again.)

This kind of behavior is not a defect. It is due to the very

high speed at which the G2 responds to patch switching.

To prevent the sound change caused by the above

condition, do not produce sound with your instrument until

the bypass/mute condition is fully established.

Play the string to tune

Play the open string to tune,

and adjust the pitch.

The left side of the display shows the

note which is closest to the current pitch.

Patch change at bypass/mute

The G2 incorporates an auto-chromatic tuner. To use the tuner function, the built-in effects must be

bypassed (temporarily turned off) or muted (original sound and effect sound turned off).

Using the Tuner

ZOOM G2

4 0

NOTE

Pitch is high Pitch is correct

Indication turns faster the more

the pitch is off

Pitch is low

Tune other strings in the

same way.

The right side of the display

shows a symbol that indicates

by how much the tuning is off.

When you turn the G2 off and on again,

the reference pitch setting will be reset

to 40 (center A = 440 Hz).

Adjusting the reference pitch of the tuner

Return to play mode

Turn Parameter knob 1.

While the reference pitch value is shown,

turn Parameter knob 1 to adjust it.

Press one of the [W]/[Q] foot switches.

If required, you can fine-adjust the reference pitch of the G2 tuner. The default

setting after power-on is center A = 440 Hz.

The current reference pitch is shown.

The adjustment range is 35 – 45 (center A = 435

to 445 Hz).

When you release the Parameter knob, the display

indication will return to the previous condition

after a while.

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Commentaires sur ces manuels

Pas de commentaire

Zoom G2 Spécifications Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour guitare Zoom G2