Zoom H2 Spécifications Page 89
- Page / 94
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
ZOOM H2
89
Error Messages
Card related messages Cause Remedy
No Card
No SD card is inserted. Insert SD card and turn power on.
No File
A valid file was not found.
Card Format Error!
SD card formatting process failed, or card
was not recognized normally.
*
Card Full!
Card became full during recording
File name exists!
File name change was attempted, but file
with same name already exists.
Specify a different file name.
Stop Recorder!
User attempted to access a menu not
available during playback or recording.
Stop the recorder operation first.
Card Protected
The SD card is write-protected.
Change setting of card's write-
protect switch.
Format Card?
SD card with incorrect format was inserted.
When you select "YES" at this
screen and then press the
5
(REC)
key, all data are erased and
initialization is carried out.
Now Recording!
User attempted to access a menu not
available during recording or recording
standby.
Stop recording first.
File Create Error!
The file could not be created at start of
recording.
*
Card Error!
A card error has occurred.
File Protected
User attempted to write to a read-only file
from the file menu.
Change the read-only file attribute
using a computer.
File Rename Error!
A blank or invalid file name was specified
during file name editing.
Do not use invalid characters.
Card Write Error
Shown when an error occurs during file
write other than recording.
*
Card Read Error!
Shown when an error occurs when opening a
file.
Data Write Error
Shown when data transfer to SD card cannot
keep up with data stream during recording.
Reduce sampling frequency and/or
number of bits.
* If card related error messages occur frequently, the SD card may be defective.
Other messages Cause Remedy
RESET DATE/TIME
The internal clock was reset because battery
backup was interrupted.
Set the date and time again. The
internal clock requires batteries to be
inserted.
Low Battery!
Battery voltage is low. Replace batteries.
Please Power Off
Shutdown procedure is complete. Set power switch to OFF.
Please pull out external input
When external mic or component is
connected, mic pattern cannot be selected.
Disconnect any external mic or
component connected to [EXT MIC
IN] or [LINE IN] jack.
Only Built-in MIC is active
External mic or component is connected,
although only built-in mic is active in 4-
channel mode.
Invalid File!
An invalid file was specified.
Select a valid file.
H2-E.fm 89 ページ ２００７年７月１１日 水曜日 午後３時１９分
- Operation Manual 1
- SAFETY PRECAUTIONS 2
- Usage Precautions 2
- Contents 3
- What the H2 Can Do 5
- Parts of the H2 8
- Left side panel 9
- Bottom panel 9
- Right side panel 9
- Getting Connected 10
- Operation on Battery Power 11
- About SD Cards 11
- Recording 12
- Insert a SD card into the H2 13
- Select the mic pattern 14
- Set the H2 to the recording 16
- Cancel the recording standby 16
- Stereo Mode Recording 18
- 120 deg 19
- Glossary 20
- Adjust the recording level 24
- Start recording 24
- Stop the recording 24
- Check the recording 24
- Bring up the stereo mode top 25
- Select the file to play 25
- Play the selected file 26
- 4-Channel Mode Recording 27
- Adjust the input sensitivity 29
- Select the file pair to play 31
- Play the selected file pair 31
- Bring up the REC MODE screen 35
- Select the recording mode 36
- Return to the top screen 36
- Using the AGC/compressor/ 37
- Bring up the LO CUT screen 38
- Activate the low-cut filter 38
- Bring up the AUTO REC screen 39
- Use the auto record function 41
- Bring up the PRE REC screen 42
- Activate pre-recording 42
- Convenient Playback Functions 45
- File Operations 47
- Edit the file name 51
- When the file name is as you 51
- Perform the MP3 conversion 56
- Perform the stereo file 58
- Data Write Error 59
- SD Card Operations 60
- Bring up the SD CARD screen 61
- Bring up the CARD FORMAT 61
- SD card dropout errors 62
- Tuning an Instrument 63
- Bring up the TUNER screen 64
- Perform tuning 65
- Using the Metronome Function 67
- Specify the metronome tempo 68
- Set the volume level for the 70
- You can now exchange files 72
- H2 and computer 72
- Bring up the USB AUDIO I/F 76
- MENU screen 76
- Cancel the connection to the 76
- Other Functions 78
- Bring up the MONITOR screen 79
- Select the desired setting 79
- Bring up the PLUG-IN POWER 80
- Bring up the CONTRAST screen 81
- Adjust the contrast 81
- Bring up the LIGHT screen 82
- Select the backlight setting 82
- Bring up the BATTERY TYPE 83
- Specifications 86
- Troubleshooting 88
- Error Messages 89
- Tips for Mic pattern setting 93
- FRONT90° REAR120° 94
Produits connexes et manuels pour Dictaphones Zoom H2
Dictaphones Zoom H4n Manuel d'utilisateur
(156 pages)
(156 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.598 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels